6-12HP 2-4Stroke Outboard Motor Heavy Duty Multi-model Boat Engine Boat Motor

  

6-12HP 2-4Stroke Outboard Motor Heavy Duty Multi-model Boat Engine Boat Motor. Don't do the following will avoid cylinder Scoring. 1, start the motor on bank. 2, use the motor when it stop coming out of water. Even if you want test the motor, it should be done in the river!

About the noise: all the gasoline machines are noisy, currently we did not test the decibel, but the noise is the same as the motorcycle, so it is a normal phenomenon 2. The machine itself is lightweight, it can use on boat weight of 100kg or less, load-bearing 4 people, but the speed is certainly not the same when one person on it or 4 people on it. Customer who has high expectations on speed, please be noticed 3. It can be marched with inflatable boats, rubber boats or fishing boats 4. Necessary: you have to prepare a boat-motor stand or Hanging board on your boat.

MODEL ONE: 3.5HP & 2-Stroke(TYPE ONE). Please add gear oil to the gears before use the motor and replace gear oil after the run-in period(10 hours). Our outboard motor doesn't with oil of gear, please prepair it by yourself. Keep in mind that you must add oil on the gear beofore use!! There is no other certification can be provided, thanks for your understanding.

Two strokes 3.5 hp and 3.6 hp are controlled by the handle, which is operated by the clutch. There is no Neutral, only idle mode or low speed mode.

STRICTLY FOR PROFESSIONAL USE ONLY Please Note: There are two pull starter included in the parcel(one is the machine, another one for spare) We don't supply wearing parts (pull starter)for free. Maximum output:3.5HP Speed:10km/h Type:2-stroke. Short shaft :40cm Ignition system: CDI system Starting system: Manual start Staring carburetion system: Choke start Propeller mark:7-1/45-A(inch) The engine and the propeller ratio:2:1 Recommended fuel: Regular unleaded gasoline Fuel to oil ratio: 35:1 (Please be suject to this version, and disregard the manual about this point) Gear ratio: 27/13 Maximum speed: 10 km / h Built-in fuel tank: 1.3L Fuel consumption per hour: 1.5L When at normal cruising, the appearance of the seventh picture. Falling back the boat, the appearance of the outboard motor likes the eighth picture.

Falling back the boat, you should drive slowly otherwise the boat will not stable. The outboard motor backet can revolve 360. Only in simple let the engine revolve 180 and the operation handle face back, the boat can fall back to drive. Announcements: After in the sea water or turbid water cruising 1.

Use the fresh water cleaning the outboard motor 2. With the moderate velocity circulating the engine, cool off the water chanel with fresh water. Before completely running out cooling water, don't put the outboard motor outside. Otherwise the water cam pass the exhaust port to enter the air cylinder, from that will cause the engine breakdown.

The engine should deposit in the aridity and ventilated well place, avoid exposing directly in the sunshine. Before the long term storing, you should run out of the gasoline in the fuel tank. MODEL TWO: 3.6HP & 2-Stroke.

STRICTLY FOR PROFESSIONAL USE ONLY. Start-In-Gear protection/clutch feature prohibits prop rotation while idling.

Lift/Tilt feature for shallow water operation and convenience. Features 360 degree steering rotation for reverse without gear shifting. Superior engine water cooling system for improved engine performance. Easy pull off engine cover with push button latch for instant motor access. Features: Features 360 degree steering rotation for reverse without gear shifting.

Standard CDI ignition system for easy starting and improved. Vertical mount engine design for increased power, performance and durability. Superior carbonation system with primer bulb for increased efficiency. Twist grip throttle handle and engine stop button for improved response. Superior outboard anti corrosion system and anodes for increased durability.

Durable cast Nylon plastic construction for superior corrosion protection. Through the prop exhaust outlet for decreased noise and pollutant. Heavy duty lightweight Nylon plastic cast propeller is standard equipment. MODEL THREE:3.5HP & 2-Stroke (TYPE TWO). What you will receive is our new version of this boat engine.

MAX SPEED:40005000rpm Maximum output:(3.5HP) Speed:12km/h(four people) Type:2-stroke. Ignition system:CDI system Starting system:Manual start Staring carburetion system:Choke start Propeller mark:7-1/45-A(inch) The engine and the propeller ratio:2:1 Recommended fuel:Regular unleaded gasoline Fuel to oil ratio: 35:1 (Please be suject to this version, and disregard the manual about this point) Gear ratio: 27/13 When at normal cruising, the appe. Falling back the boat, the appe. Nce of the outboard motor likes the. Falling back the boat, you should.

Drive slowly otherwise the boat will not stable. Outboard motor backet can revolve 360. After in the sea water or turbid water cruising 1. The engine should deposit in the aridity and ventilated. Well place, avoid exposing directly in the sunshine.

MODEL FOUR:4HP & 4-Stroke. Notice:Please add gear oil to the gears before use the motor and replace gear oil after the run-in period(10 hours).

About certification: We can only provide CE certification, there is no other certification can be provided, thanks for your understanding. STRICTLY FOR PROFESSIONAL USE ONLY Type: 4 stroke 4 horsepower.

Short shaft :40cm Capacity: 52cc Transmission ratio: 2.08 (27:13) The number of cylinders: 1 MAX SPEED:45005500rpm Maximum power: 4 HP Shift position: clutch control Package volume: 95x40x30 cm Ignition system: CDI Cooling system: air cooling Starting method: Manual start Refueling: No. 93 gasoline Propeller size: 7 1/4X7-A The maximum fuel consumption: 1.4 liters / hour Recommended Lubricant:4 stroke lubricating oil Mixing ratio:Pure gasoline Trim and tilt system:Manual Tilt Start-In-Gear protection/clutch feature prohibits prop rotation while idling convenience Features 360 degree steering rotation for reverse without gear shifting Cooling system: air cooling Easy pull off engine cover with push button latch for instant motor access. MODEL FIVE:6HP & 2-Stroke. Overall length 1040mm(40.9 in).

Overall width 872mm(34.3 in). Overall height 332mm(13.1 in). Transom height 44CM(17.3 in). Idling speed (in neutral) 1000±100 r/min. Gear ratio 2.15(28/13).

Trim and tilt system: Manual tilt. Recommended fuel Regular unleaded gasoline. Integral fuel tank capacity 2.5L. Recommended engine oil 2-stroke outboard motor oil. Engine oil type Genuine or recommended 2str engine oil.

Lubrication System Engine oil mixed gasoline. Engine oil mixing ratio Fuel 50: Engine oil 1.

Gear oil quantity 195ml6.6 fl. Spark plug 25.0Nm(18.4 ft-lb) (2.55 kgf-m). Engine oil drain bolt 18.0Nm(13.3 ft-lb) (1.84 kgf-m). MODEL SIX:7HP & 4-Stroke.

Please add gear oil to the gears before use the motor and replace gear oil after the run-in period (10 hours). If you do not know how to handle this, please contact with us. We can only provide CE certification, there is no other certification can be provided, thanks for your understanding. All the gasoline machines are noisy, currently we did not test the decibel, but the noise is the same as the motorcycle, so it is a normal phenomenon.

Customer who has high expectations on speed, please be noticed. It can be marched with inflatable boats, rubber boats or fishing boats.

Firstly, Fill the gear oil (open gear box lid and fill it). 92 petrol, lightly press oil pump 6-10 times. Thirdly, Fill engine oil don't exceed the head of the pattern. Forthly, Pull the gear to netural gear, and plug the brake line in, hang the other side of the brake line on your wrist at the same time.

Then, turn the accelerator gets up to 50% and rapidly pull the starter line. After the motor start, please turn the gear to minimum before put another gear.

Otherwise, the gearwheel will be broken if you put high gear. Universal motors, high performance, reliable quality. · Perfect match inflatable boats, fishing boats, sailboats, and small yachts. · Economical and compact structure.

Durable, lightweight and anti-corrosive construction. · Maneuverable and safe twist grip throttle control.

· Suitable for: Freshwater and saltwater. Type: 4 stroke 7 horsepower. Transmission ratio: 2.08 (27:13).

The number of cylinders: 1. Package volume: 120x60x42.5 cm. Propeller size: 3-7 1/2''x5'. Trim and tilt system: Mannual tilt.

Standard fuel tank capacity: 1.4L/within. MODEL SEVEN: 6.5 HP & 4-Stroke. Provides all the power you need for motoring in a small craft. This engine does that as well as providing fuel efficiency second to none and a newly redesigned carrying handle and holding grip make it convenient to transport! With all of this available at a competitive price, it is no wonder this little outboard receives so much attention and praise!

Displacement: 123CC Gear ratio: 2.08(27:13) Cylinder: 1 Max. Gear Positions: F-N-R Packing size: 114x64x41cm Ignition System: CDI Cooling System: Water-cooling. Control System: Tiller control Starting System: Manual start Control System: #93 gasoline N. (kgs): 26/31.2 Bore x Stroke(mm): 59x45 Recommended Propeller range: 3 -7"x9" Recommended Lubricant: Four Stroke Lubricating oil Mixing ratio: Pure gasoline Trim and tilt system: Manual Tilt Overall LxWxH(cm): 78.3x34.3x103.9 Standard fueel tank capacity: 12L Optional fuel tand capacity: /.

Pump impeller, start rope, start key. 12 liter fuel tank, tool kit, spark plug, cylinder head pad. Forthly, turn the throttle to the start up and turn the accelerator gets up to 50%. Then, Rapidly pull the starter line.

After the motor start, please turn the throttle to running state. Then, it can be operated now. 1, start the motor in the water. 2, use the motor when it stop cyling water.

When there is no water coming out from the motor, please stop using it immediately, then check the impeller of Water pump or check if the water outlet has been blocked. Several issues with this motor first the linkage that goes from the gear selector to the starting rope to block the rope to be pull when the motor is in gear was unattached, and still after fixing it every time you go into any gear it gets unattached second, the starting rope doesn't retract all the way when you attend to start the engine. Gear ratio: 2.08(27:13). Packing size: 120x70.5x37.5cm. Bore x Stroke(mm): 50x43.

Recommended Propeller range: 3 -9"1/4''x8". Recommended Lubricant: 2 Stroke Lubricating oil. Mixing ratio: Fuel:oil=50:1. Trim and tilt system: Manual Tilt.

Overall LxWxH(cm): 78.3x33.2x104. Standard fuel tank capacity: 24L external oil tank. Bore x Stroke(mm): 56x50. Overall LxWxH(cm): 78.3x33.2x105.3.

Standard fuel tank capacity: 24L. Feedback is very important to us. It is impossible to address issues if we do not know about them! Faction is our ultimate goal.

We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately.

If it's non-workdays, please kindly be patient and wait till Monday. This item is in the category "eBay Motors\Parts & Accessories\Manuals & Literature\Boats & Watercraft". The seller is "galaxyond" and is located in this country: US.

This item can be shipped to United States.

• MODEL: 6HP & 2-Stroke
• Cooling System: Water-Cooling
• Brand: HANGKAI
• Boat & Watercraft Type: Outboard Motors
• MPN: 133459958543